MOT – Checks to help pass your cars MOT test

If it’s time for your Figgies MOT test, you might be worried about whether it’s going to pass or fail. Thankfully, there are quick checks that you can do to give your vehicle the best chance of passing. Many vehicles fail their MOT because of small silly issues like faulty bulbs or even a dirty number plate.

Read below and take a look at our video to find out which car checks to do in advance of your MOT.

You should aim to do these checks in enough time to get any problems repaired before your MOT if they’re too difficult to manage yourself.

TYRES
The minimum legal tyre tread depth is 1.6mm in a continuous band around the central 3/4 of the tyre. Any tyres with less than this will be marked as an MOT fail. Tyre tread is easy to check as most tyres have tread wear indicators – you can find these raised ridges running across the tyre in the bottom of the grooves. The ridges are 1.6mm high, so if the tread’s worn down to the same level the tyre needs replacing before the MOT. See tyre specification and where to buy Click here

WINDSCREEN, WIPERS AND WASHERS
Carefully check the car windscreen for any damage such as cracks or chips. Any damage of 10mm or more in the A-zone of the windscreen (a 290mm area directly in front of the driver) will result in an MOT fail. And if there are any chips or cracks 40mm or more on the rest of the “swept” part of the windscreen (area covered by the wipers), this will also result in a failure. Damage to any part of the windscreen outside the “swept” area won’t result in a failure, but you may still be advised to get it fixed. Windscreen stickers or other obstructions to your view may also cause an MOT failure. For wipers, test they can still clean the front and back windscreens properly and that your washer fluid is topped up.

FUEL AND ENGINE OIL
Your car will need enough fuel and engine oil for its MOT. The MOT tester will need to run the engine to check exhaust emission levels and might refuse to test your car if the fuel or engine oil level is too low. You can easily check your engine oil level using your dipstick.

LIGHTS AND INDICATORS
Check the headlights, number plate lights (at least 1 of the 2 lights needs to be working to pass your MOT test), brake lights, hazard lights and indicators are all working as normal.

NUMBER PLATE
Make sure your number plate is clean and readable – a quick wash is sufficient. The font and spacing of the number plate characters must also comply with legal requirements.

EXHAUST
Check there are no unusual, excessive noises or rattles coming from your exhaust.

SEATS AND SEATBELTS
Test to see if the driver’s seat moves normally and locks securely in any position, without any difficulties. For seatbelts, check everyone fully to see if they:
– Have any cuts or fraying.
– Retract properly.
– Are securely attached to the floor or seat.
– Clip in and unclip without hassle.
– Are locked in properly once clipped.

HORN
Test your vehicle’s horn – try and do this somewhere where it isn’t likely to startle other drivers, cyclists or pedestrians. If it doesn’t work, it’ll need to be repaired or replaced.


WATCH VIDEO

What else can fail a car MOT test?

Using the checklist above will hopefully give your vehicle the best chance of passing an MOT test. But there are many other parts of your car that, if not working correctly, could cause a failure. These include (but are not limited to):

Car battery – a leaking battery or one that’s insecure and looks likely to fall from the carrier will also result in a failure. (If it’s insecure but doesn’t look likely to fall from the carrier, this is classed as a minor fault so won’t automatically result in a fail).

There are also aspects of your car that may only result in a “minor” defect, such as a brake fluid warning light showing or being below a minimum level (although if it’s significantly below a minimum level, it will be classed as a major fault and therefore an automatic fail).

A “minor” defect won’t result in a failure, but should still be fixed as soon as possible. If you are experiencing any issues with your vehicle, including any warning lights flashing up, then it’s best to get them checked as soon as possible. This isn’t just in order to pass your MOT but to make sure the vehicle you’re driving is safe and roadworthy.

MAKE SURE YOU CHECK THE MILEAGE ON THE MOT TEST CERTIFICATE!

If your Figaro has KMS to MPH card fitted in the speedo gauge when you receive the paperwork from the garage, make sure you check the mileage has been recorded correctly. Even the founder of the Figaro Owners Club has been a victim of this as the example on the left shows!

The garage had recorded 2 years in Miles not Kms until they corrected it during the following year. This could affect the value of your car if you decide to sell it during the time the error has been documented.  

Can an MOT test be done early?

Many drivers arrange their MOT test close to the expiry date of their current one. It’s worth noting your car can be tested up to a month early, and still hold the same anniversary date. If you take your car in early and it fails the test, the old certificate will still be valid. This might mean that technically you still have a current MOT but you can’t ignore the fault and continue driving the car.

Remember, it’s an offence to drive an unroadworthy vehicle – you could be fined or even banned from driving.
What happens if you disagree with your MOT test result?

 

Published on 3rd November 2022